I bought my 2011 Mazda 3 over two years ago and passenger window didn't work, recently both rear windows are doddgy - I can lower them but they are not going up (switch on rear door were working but not anymore). Only my driver side windows is working normally. Also, passenger mirror doesn't fold. All fuses are OK. After playing with the driver's side switch for the right rear window for a couple of minutes I found it started working if I pulled up a bit more forcefully on the window switch. Since the car is new and the window worked using its local switch and worked in the down direction from the driver's side switch I figured maybe it was just something Procedure. Unlock the vehicle and go to the driver’s seat. Locate the window switch on the vehicle’s door panel. Pop the window switch out on the bottom using a pick tool or a screwdriver and pull it back to remove it from the door panel. Disconnect the electrical connectors of the window switch by pushing the clip and pulling the connector 1. The auto door-lock function is disabled. 2. All the doors and the liftgate lock automatically when the vehicle speed is about 20 km/h (12 mph) or more. 3 (Factory Setting) All the doors and the liftgate lock automatically when the vehicle speed is about 20 km/h (12 mph) or more. Driver's window switch controls not working in your Mazda? Could need simple reprogramming, fix shown here. Car demonstrated is 2006 Mazda 3 but similar process for other Mazda cars. 6. Turn the ignition switch to on (ll) 7. Release the power window switch. Note: Make sure the auto-up feature doesn't work. If it does, repeat steps 4 thru 7 again, paying close attention to the 5 second time limit for up to 3 more times for each series steps. 8. Lower the window all the way down with the power window switch. 9. My problem is the driver's power window does not work. In my attempt to diagnose the problem I found that when i press the up button both of the power wires on the motor receive electrical current. When I press the down button no current is received on the motor wires. At the switch power is transfered properly to the signal wires for up and down. Passenger window won't roll up/down 2009 mazda 3. Just happened a few minutes ago, all other windows work. Neither the drivers side switch or passenger switch work. I don't hear any kind of electric struggling or whining from the door. Tried to "unstick" it manually while using the switch and without. 2. Open passenger window completely from passenger side window switch. 3. Close passenger window completely from passenger side window switch, and hold switch for an additional 2 seconds. 4. Turn ignition back to "lock" position. EKYM1n5.

mazda 3 window switch not working